Cisel Recital Hall Concert Lighting Instructions

*Do not program any lights without permission.

Before the Concert

  1. Place all LED Pars are placed in their spiked locations and are switched on (both switches - battery and power)
  2. Double check the aim of each Par light (white tape with black line should be aligned)
  3. Turn on the entire system
    • 2 switches on the light board
    • Audience & Overhead Stage button
  1. Press the Scene 8 button to set the Pre-Concert Lighting to Dim
  2. When the performer(s) are ready to begin the concert, press Overhead Stage Only, then wait a few seconds.
  3. When the performer(s) are ready to go on, press both Overhead Stage & Front Light Bar and Scene 1 at the same time before opening the door. Any scene can be used.
  4. (optional) If the performer(s) prefer that the lights change throughout the performance, ensure that Chase 1 and Auto/Del are active in the display. Set the Faders on the right of the light board to 1 second fade and 5 minute speed.

During the Concert (non-intermission)

  1. After the performer(s) leave the stage, press Scene 8 and Overhead Stage Only at the same time to dim the (PressAuto/DeltopausetheChaseifnecessary).
  2. When the performer(s) are ready to return, press Overhead Stage & Front Light Bar and Scene 1 at the same time before opening the (Press Auto/Del to reenable Chase).

During the Concert (intermission)

  1. After the performer(s) leave the stage, press Scene 8 and Audience & Overhead Stage at the same time to dim the (PressAuto/DeltopausetheChaseifnecessary).
  2. When the performer(s) are ready to begin again, repeat steps 5 and 6 (and 7)

After the Concert

  1. After the performer(s) have left the stage, press Audience & Overhead Stage and Blackout to end the
  2. When the stage crew is prepared to clear the stage, simply turn off both power switches on the light board and the overhead stage lights will turn on to their default setting.
  3. Ensure that all the Pars are turned off and, if necessary, put back in the case to recharge (less than 50% battery left). They can be left out otherwise.